Oliver 1650 w/ 283D February 23, 2017 12:11PM
I'm looking to build up my Waukesha 283 for some pulling. I'm new to the Waukesha's and am curious what is the best route for increased horsepower outside of injection pump work. What parts can be interchanged with a 310? Thanks for the help.
Reply Quote

Re: Oliver 1650 w/ 283D February 24, 2017 10:25AM
1 piece connecting rod bushings and 12 point bolts for the connecting rods are a must have on the 283/ 310 waukeshas.
the only difference between the 283 and 310 is the stroke. the crank and rods are different and the rest should interchange
Reply Quote

Re: Oliver 1650 w/ 283D February 27, 2017 01:40PM
The rod length is the same between 283's and 310's. Some of the indirect injection 283's used a straight cap design, but all the direct injection 283 rods are the same as a 310. The 310's had to go to a offset cap for clearance with the extra stroke. The pin height in the piston was where they made up for the stroke difference.
Reply Quote

Re: Oliver 1650 w/ 283D February 28, 2017 02:03AM
Not trying to be condescending but , get a Cummins for your 1650. You will be a lot happier.
Reply Quote

Re: Oliver 1650 w/ 283D February 28, 2017 02:43AM
please dont put a cookie cutter 5.9 in yer oliver. build up that 283 to a 310 and have some fun.
Reply Quote

Re: Oliver 1650 w/ 283D February 28, 2017 09:52AM
Eric
I HAVE COMPLETE 310 FOR PULLING WITH 645 ROOSAMASATER GIVE ME A CALL 419-357-1817 Rodger
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,565, Posts: 229,582, Members: 3,319.
This forum: Topics: 37,056, Posts: 225,843.

Our newest member BadHabit2