504 pistons in 466 March 29, 2020 12:10PM
I know this has been asked before but here goes. I have a 466 block thats bored for 4-5/8” sleeves and an ih 5.75” crankshaft so can i use case pistons and sleeves in this motor and if so what rods do i use? Can i use factory rids n mill off the top of pistons. This is for a nautrally asperiated diesel antique puller
Reply Quote

Re: 504 pistons in 466 March 30, 2020 04:40AM
I did this same setup many years ago, use the big pin 407 rods (1456), and the small pin 504 Case pistons (2090, 2290), and works out well.
Reply Quote

Re: 504 pistons in 466 March 30, 2020 05:24AM
Thanks for the help. Those pistons will work with 407 rods and the stroked 5.75 crank? If so i have the rods ill just need 504 pistons and sleeves
Reply Quote

Re: 504 pistons in 466 March 30, 2020 07:54AM
You will have to mill the pistons some to get correct deck height if I remember correctly, and re-do your valve reliefs depending on the lift of your cam...
Reply Quote

Re: 504 pistons in 466 March 31, 2020 11:48PM
I have a set of Case pistons that I took out of my hotfarm when I switched to billet if your interested.
Reply Quote

Re: 504 pistons in 466 March 31, 2020 11:57PM
Yes i may be interested in them can u text or call me 270-993-4645 thanks
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,598, Posts: 229,641, Members: 3,322.
This forum: Topics: 37,060, Posts: 225,873.

Our newest member JD_8520