Foaming Rearends December 01, 2022 10:01AM
What are you guys using to foam rearends that holds up well with the oil?
Thanks in Advance

Re: Foaming Rearends December 02, 2022 02:44AM
Any kind of foam will work but the thing you went to do is to put a think coat of silicone between the foam and oil

Re: Foaming Rearends December 02, 2022 06:11AM
I have seen too many rear ends with foam that got loose into the gears, bearings, ect, so I put mine in 1/2 gallon plastic jugs that fit together neatly in the space I had, then wrapped them with a band of aluminum,and anchored it to an inside stud I installed, then put a thin layer of foam over the "bundle" I created inside, only had a 6 inch hole. I left about half an inch between bull gears and bundle. Going higher than the oil level you intend to use is not needed.

Re: Foaming Rearends December 02, 2022 06:58AM
I should add that I filled the jugs with foam.three yrs, all good.

Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,576, Posts: 229,605, Members: 3,319.
This forum: Topics: 37,058, Posts: 225,857.

Our newest member BadHabit2