clutch blanket on 4010 May 01, 2012 02:15PM
putting a clutch blanket on 4010. wondering about cutting blanket for shifting rods and clutch pedal. Is this the best way or somthing better. thanks
Reply Quote

Re: clutch blanket on 4010 May 02, 2012 03:49AM
Heat a piece of pipe or a piece of rod the size of your shifter lever with a torch, and poke it through the blanket. Makes a nice hole in the blanket for bolts, levers, and the like.
Reply Quote

Re: clutch blanket on 4010 May 02, 2012 05:14AM
Take an old hole saw, grind off the teeth & sharpen the edge somewhat. Remove pilot twist drill & use in drill press to cut thru. Makes clean hole.
Reply Quote

Re: clutch blanket on 4010 May 02, 2012 07:54AM
i used a heated piece of pipe for round holes and heated the side of a peice of angle metel with torch for clutch linkage 3inch to 4 for travel by burning through there are no frayed ends
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,769, Posts: 229,936, Members: 3,338.
This forum: Topics: 37,095, Posts: 226,026.

Our newest member Jacklovik2009