anybody know of some 4.625 pistons with a compression ratio in the ballpark of either 3 and 5/8" or 2 and 7/8" compression height? preferably 1.6" or bigger pin size. we already looked into custom and apparently its hard to even find blanks that size.
If you're thinking custom, call Ross. If you can draw it, they will make it, and for a lot less than it's worth putzing around trying to make something else work. They did a set for me for a BIG cube MM and they looked so nice when I got them, I almost hated to put them in the motor.
Is the bowl off center in a 2290 4.625 piston? Like the 4.375 451 bdt piston? I would use them for a project if they were in the center. Thanks for any positive input.
