05:26:24am, Sunday, May 19, 2024
Deere 404 head bolt help needed
|
Anonymous User
|
Does anybody know the torque specs and torquing sequence for a 404 turbo head? Can't find anywhere |
Re: Deere 404 head bolt help needed
|
Anonymous User
|
The torque sequence is basically like any other multi-cylinder head. Start in the middle and work towards the ends alternating back and forth from the middle. I got a print out from my local JD shop. The sequence is also in an IT service manual. As for torque, that depends on the type of head bolt. I was told the flange head bolt can be reused, the ones with seperate washers should not. I torqued the head on my 4430 to 150ft/lbs in three steps, that was with the flange head bolts. |
Re: Deere 404 head bolt help needed
|
Maddie
|
Usually torque them to 300 ft lbs, then they hold all that Greeen power |
Re: Deere 404 head bolt help needed
|
New way
|
The way we do it now at the shop is do the center bolt then just start at the corner and work ur way around into the middle do a 120 150 180 |
Re: Deere 404 head bolt help needed
|
Puller xxiv
|
I take my air gun in three steps low. med.and high don't take long that way |
Website Statistics
Global: Topics: 38,779, Posts: 229,957, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,040.
Global: Topics: 38,779, Posts: 229,957, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,040.
Our newest member Jacklovik2009