Billet connecting rods Murphy's Motorsports December 02, 2016 01:02PM
Does anybody know about Murphy's Motorsports Billet connecting rods for a DT 466

Re: Billet connecting rods Murphy's Motorsports December 02, 2016 02:02PM
For farm pulling they would proll be ok. Otherwise no good

Re: Billet connecting rods Murphy's Motorsports December 02, 2016 02:08PM
What was so bad about them? That you would only use them Farm pulling

Re: Billet connecting rods Murphy's Motorsports December 02, 2016 11:47PM
We had a mishap on the dyno that resulted in putting the piston thru the block on a customers motor. The cause of the failure was the piston. The rod bent but did not fail. Based on what we saw from this, I wouldn't be afraid to use his rods. They were used on a large ci motor and high RPM's.

Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,793, Posts: 229,998, Members: 3,340.
This forum: Topics: 37,103, Posts: 226,072.

Our newest member Jacklovik2009