C301 head mill May 20, 2017 01:01AM
I have recently purchased a farmall 560 with a c301 in it. It also has a homeade draw thru turbo setup on it. I was originally planning on leaving the turbo on it and just pulling in local open classes. However the more I think about it the more I think I need to switch it back to n/a. Just don't think there will be enough pulls in the area that will allow me to participate. Short block is stock other than a reground cam. How much can I safely mill the head. How much increase in compression will it make. Is it worthwhile?

Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,645, Posts: 229,712, Members: 3,325.
This forum: Topics: 37,067, Posts: 225,904.

Our newest member JD_8520