01:55:40am, Friday, May 03, 2024
new NTPA rule (hot off the presses)
|
Registered: 07/06/2008 Posts: 1,347 |
Kudos for being proactive! From NTPA Tech page:
Late-Breaking News: Attention all pullers, updates to general rules effective immediately: The following words are deleted from page 23 of NTPA rulebook number 4: “if not bolted directly to gearbox or back of belhousing with a minimum of three 3/8” grade 5 bolts” It now reads: 4. The following rule will apply to all divisions that use solid driveline shields over 16 inches in length: Note: this also applies to Mini Rod division and the intermediate shaft on FWD. All free-floating driveline shield components must be tethered on each end by two opposing restraints, Tethers must attach at 180 degrees of each other and a minimum of 3” and a maximum of 6” from each end of each driveline shield component. Tether to be constructed of a minimum of 5/16 “ chain or 2” wide by 1/8” thick nylon strap. One end of tether must attach to driveline shield by a minimum of one 3/8” grade 5 bolt attached to a tab (minimum 2”wide) to be welded to shield while the other end of tether must be attached to chassis by a minimum of one 3/8” grade 5 bolt. Note: FWD drivelines that use driveshaft hoops must use same tether configuration to be attached to main or common hoop holder between chassis and hoop assembly. |
Re: new NTPA rule (hot off the presses)
|
Registered: 11/24/2019 Posts: 242 |
Not sure if it was here, but saw that Thursday or Friday. Glad no one was hurt in the incident, and good on them for doing it right away. |
Website Statistics
Global: Topics: 38,678, Posts: 229,780, Members: 3,328.
This forum: Topics: 37,078, Posts: 225,950.
Global: Topics: 38,678, Posts: 229,780, Members: 3,328.
This forum: Topics: 37,078, Posts: 225,950.
Our newest member Jason