Page 1 of 1 Pages: 1
Results 1 - 6 of 6
Not sure what the attitude is about but I was simply stating where I was pulling the numbers from. Was not trying to be smart. The fact that InjPumpEd mentioned the metric conversion make much more sense. My main question is, which will flow more and roughly by what percentage. If the two nozzles are within 5 to 10% of each other, then I will not waste my time. The 500cc part is only theoretical
by
Nick Reed
-
Forum
Bear in mind that the tip size numbers that I am using are from the Deere Parts Catalog. The AR73100 is 4x0.40 or 4x0.36 as written in the catalog. The RE48480 is 7x0.255 as written in the catalog. These are not EDM's. Just factory nozzles. The 4 hole is from an 860B scraper and the 7 holes are from an 8870.
by
Nick Reed
-
Forum
Theoretically, if a pump was putting out 500cc of fuel, what would be the difference between running a 9mm tip that is 4x0.40 vs a 7mm tip that is 7x0.255 in percentage or volume wise. I have a set of each and am debating on which to install. I have the 7mm to 9mm adapter washers already for the smaller tips to be ran in the larger injector holes but I am not sure if the swap will be worth it. An
by
Nick Reed
-
Forum
I have installed gov springs and delivery valves in a P7100 RQV pump in the past and those were straight forward. How do I go about setting the governor for 3k rpms in a RSV gov? I assume there are different springs available for the internal arm? Where can these be purchased and are they color coded? This is for a PES6P110 pump on a Deere 619. Thanks in advance
by
Nick Reed
-
Forum
Thanks for the info guys!!
by
Nick Reed
-
Forum
After searching through about 25 pages of search results, I am just going to ask. I am getting my fathers 5020 back running again after the engine managed to get filled with rainwater and freeze. I have sourced a 619 from a 860B scraper and am swapping manifolds while I am waiting on the clutch to get rebuilt. The tractor was turbocharged before the 531 block froze and busted. It had a 3LM-299 fr
by
Nick Reed
-
Forum