Page 1 of 1 Pages: 1
Results 1 - 14 of 14
thanks
by
cws2011
-
Forum
Just wondering if anyone out there would be willing to share what a arms they are using for air ride suspensions. Jist assuming they are available prebuilt and not custom made. Thanks
by
cws2011
-
Forum
Looking for some information if anyone is willing to help me out. Feel free to pm me. I looking for information about if different governors from different model pumps are interchangeable with the p7100. Also looking for a good place to source parts. Thanks
by
cws2011
-
Forum
if you have to pay for machine work id agree with you. But we can do the machine work, which is why I was trying to do over-sided pistons if they were easily available.
by
cws2011
-
Forum
Out of box 3lm turbo. 3250 rpm limit.. prolly correct on the best to stay stock. Just was hoping to be able to clean up what we got and get new pistons to run.
by
cws2011
-
Forum
478 cubic limit.. was wanting to just use the old liners. Machine and hone them with oversized pistons..
by
cws2011
-
Forum
Any know where I am able to get .050 or .060 over pistons for the ih 466?
by
cws2011
-
Forum
I believe I see what your saying about notching out the mounting plate for the rack end plug just based off looking an pictures of new ih pulling p-pumps. Im sure we can just machine the adapter/gear hub from a 25mm taper to a 30mm to mate with 7100, or just might be better to machine a complete new. Guess we will see when we get both units pulled apart and try to mate them together.
by
cws2011
-
Forum
gotcha. so it would work with the smaller shaft p3000 pumps.
by
cws2011
-
Forum
I believe I seen in another post about the gear and mount being the same but was hoping to verify.
by
cws2011
-
Forum
So form what im gathering, i can remove the mw pump, swap the gear to the p pump and it will mount right to the old mw adapter plate?
by
cws2011
-
Forum
I am looking for information on injection pumps. We have a 89 dt466 with the mw injection pump on it. We are planning to put the ag front gear cover on it. I see that the p3000/p7100 that are on the 94-96 are a left hand rotation pump. If I mount the p7100 in place of the mw pump, do you need a left hand rotation pump or right hand? i see majority of the right hand pumps are for the cummins 5.9.
by
cws2011
-
Forum
Does anyone know if he still makes them or know of anyone who does?
by
cws2011
-
Forum
What's everyone opinion on what ih platform to start to build a super farm? I have seen alot of people saying you can just pick whatever your favorite tractor is and start building. Ive also seen alot of people start off with 706 rear ends with 66 clutch housings and frame rails to fit a 466 block/clutch setup. I guess my big question is, are most of these 06-56-66 series parts relatively in
by
cws2011
-
Forum