Page 1 of 2
Pages: 12
Results 1 - 30 of 34
How important is the angle
by
angusfarmer
-
Forum
How would swirl help on a diesel would it help with water air mixing
by
angusfarmer
-
Forum
Are you sure it’s not an A pump
by
angusfarmer
-
Forum
I was also wondering this who has the front cover what all machining has to be done
by
angusfarmer
-
Forum
I think that’s the magic question do you stroke the engine get more torque or bore it out and maybe run higher rpms?
by
angusfarmer
-
Forum
I am also curious about this class besides the turbo and fuel system what expense am I missing? I was thinking it would be more on the driver and how he read the track.
by
angusfarmer
-
Forum
Is there a demand in machining pistons?
by
angusfarmer
-
Forum
Why not just advance the timing until it starts to fall off
by
angusfarmer
-
Forum
Are you allowed to use air to water inner coolers
by
angusfarmer
-
Forum
How much horse power will stock 466 rods hold
by
angusfarmer
-
Forum
I have a 786 IH the light will get very bright. The volt meter is pegged. The battery's are sizzling I never heard of a alternator over charging,
by
angusfarmer
-
Forum
So the longer rod makes the angle less from the piston?
by
angusfarmer
-
Forum
If I have a engine that is the same cubic inch. What would have more torque a long stroke small bore or a big bore and a short stroke?
by
angusfarmer
-
Forum
Why don't the SS tractors have a stroked crank? How far can you stroke one?
by
angusfarmer
-
Forum
Can a stock or a welded 466 IH crank shaft run 5000 RPM ?
by
angusfarmer
-
Forum
What does it take?
by
angusfarmer
-
Forum
IH 530 - 9 years ago
Did anyone take a DT 530 engine and put it in a tractor?
by
angusfarmer
-
Forum
How many bushels do you usually yield for corn?
by
angusfarmer
-
Forum
How many years would it take to pay off the acre? What state are you in?
by
angusfarmer
-
Forum
What makes the aluminum head so good?
by
angusfarmer
-
Forum
My neighbor had a 30 inch water pipe and he needed more volume. He figured out going with another same size pipe or going bigger Going 2 inches bigger was more than another same size pipe. I think if you go bigger valve than 2 smaller valves would be more of a advantage.
by
angusfarmer
-
Forum
If you have engine that is starving of air? Would a bigger stroke help with torque?
by
angusfarmer
-
Forum
What about Cenpeco?
by
angusfarmer
-
Forum
How much horse power would a 466 gas make?
by
angusfarmer
-
Forum
Where would you put the distributor at? Does the cam have the gear to drive that?
by
angusfarmer
-
Forum
What does it take to make a gas 466 out of a diesel?
by
angusfarmer
-
Forum
I have a old 466 IH engine out of a truck. What machining would it take to get a 570 kit in it?
by
angusfarmer
-
Forum
Where is the web info on this club? Who cares what they call it. It should be all fun.
by
angusfarmer
-
Forum
Is there is ratio between cubic inch and turbo size?
by
angusfarmer
-
Forum
I was told with a turbo size limit and open RPM that bigger Cubic inches will hinder the engine because all the exhaust has to funnel through a small turbo.
by
angusfarmer
-
Forum
Page 1 of 2
Pages: 12