Page 1 of 1 Pages: 1
Results 1 - 13 of 13
Is there any disadvantages to mounting wheel weights to the rims? I am thinking about doing it also but am trying to decide if it will take more power to start the wheels spinning and keep the wheels turning or if I am just over thinking things.
by
pathrone
-
Forum
I dont believe there are any tax breaks for the seller as far as purchasing land goes. However if you are buying and qualify for the begenning farmer program they have a loan program that is very low intrest and will come in as the 2nd mortgage company which means they have 2nd lean and whom ever you use for the remaining funds will have 1st lean. I believe fsa will only loan 250 or 300k total
by
pathrone
-
Forum
Is a 4010 gas rearend any good to use in a hot farm situation? Would want to needle and 3spd it.
by
pathrone
-
Forum
I have an awesome set up for my 4320. Have 5x20 injectors and 450 roosa with .093 lines puts out 440cc. I run a electric pusher pump with 3/8'' lines. It runs amazing. The setup isn't cheap but if you want to give the red 66 fits this will do it. May all be for sale as I may be moving up to bigger things.
by
pathrone
-
Forum
I was told that the valves will hit the sleeves on a 404 due to the smaller bore in the 404 it puts the valves above the sleeves. Not sure what your setup is but to much air flow could hurt you rather than help you. You need to have the proper fuel and air ratio to make the most power. To much of 1 and not the other is no good.
by
pathrone
-
Forum
Any class info and rules on the leigh antique/farm pull this Saturday?
by
pathrone
-
Forum
Will a Kenny's dual disc go into a stock 4320 without any modifications?
by
pathrone
-
Forum
Beings the rpm's are the same I would think you would be better off with the cubes and torque. Unless the intercooler and ice box would make that much difference but I have no experience with that type of set up.
by
pathrone
-
Forum
Does anyone make timing tape that can be stuck to a 4320 Flywheel? I measured and just used masking tape but I'd like to be more precise.
by
pathrone
-
Forum
Can you text me a picture and price? 4zero2-4eight0-2five7two
by
pathrone
-
Forum
Does anyone make an adjustable hitch for a 4320 farm puller that doesn't require the pto to be removed?
by
pathrone
-
Forum
Any place I can aquire the shims? Its still gonna be used for light farm. Mostly auger and generator.
by
pathrone
-
Forum
Is there a bolt on replacement water header you can put on a 404 motor that will allow you to run a 55 series exhaust manifold?
by
pathrone
-
Forum