Page 1 of 1 Pages: 1
Results 1 - 4 of 4
i have a 4440 that i am pulling the engine out to put in a p pump block.
i have noted that the new block engine front mount where it mounts to the frame rail is the larger bolt pattern.
is there a different model (4450?) frame rail that will work instead of cutting the frame rail and welding in a plate to fit .looking to keep it a nice clean look.
all ideas welcome
by
cmnsndeere
-
Forum
We mounted a couple onto our 55 series tractors and had a great improvement. We're running hx40 with 16sqcm turbine housings.
Response is better and egt dropped a lot.
by
cmnsndeere
-
Forum
All great ideas, thank you very much. The angle seems to be the best for me. I have an extra water manifold so I may have mine machined. I'll keep your number on hand mueller.
by
cmnsndeere
-
Forum
i have a 4440 and made some minor upgrades and now am trying to fit an hx40 to the engine.
i have the stock water manifold, intake and exhaust manifolds. the only problem is when i turn the compressor housing to go to the intake it hits the water manifold.
i know a 1/2" flange spacer will lift the turbo far enough to where it will work but it gets close to the hood and i dont want to burn the
by
cmnsndeere
-
Forum