Page 2 of 4
Pages: 1234
Results 31 - 60 of 117
Hillbilly from Bedford
by
turbo
-
Forum
Just talked to Patrick and Both MPH classes will have a $500 purse. Also all looks good did not get very much rain there.
by
turbo
-
Forum
Where does a person get the thick gaskets for T-4 bolt pattern.
by
turbo
-
Forum
4850 is same manifold did not change manifolds till 55 series.
by
turbo
-
Forum
3LM33 from a 4850 will work fine and bolt right on with no problems and be able to farm with it.
by
turbo
-
Forum
Very old Rursh 5 disk steel flywheel and pressure plate. SFI approved.
by
turbo
-
Forum
Never had a problem with mine been pulling it for 20 years. Can slip it as much as you want.
by
turbo
-
Forum
Is there any MPH farmstock pulls with in 2 hrs of southern IN this weekend.
by
turbo
-
Forum
Does that work on stainless lines.
by
turbo
-
Forum
I always just use a air hammer and drive it through it will shear off roll pin and come on out.
by
turbo
-
Forum
Call that number will answer questions.
by
turbo
-
Forum
It is on right now.
by
turbo
-
Forum
Back to top.
by
turbo
-
Forum
Wanting to know if any pulls around Chesterfield area tomorrow night. Thanks.
by
turbo
-
Forum
Bump to top.
by
turbo
-
Forum
Looking for phone number for place in Booneville IN that makes radiators. Thanks.
by
turbo
-
Forum
I may have what you need for a dash and cowl out of a 6430 has brake pedals and clutch pedal. Give a call 812-309-3255
by
turbo
-
Forum
Your C1 clutch is welded together and when in gears 3-6 it trying to engage both at the same time. That is why it works in 1-2 when C1 is engaged and 7-8 when both are engaged. Have a Dealer Print you out a element engagement chart and you will see what i am talking about.
by
turbo
-
Forum
Anybody have results from last night. Top five would be nice. Thanks.
by
turbo
-
Forum
Website says 12NA,12, 8mph, 13, 10mph and 13 open.
by
turbo
-
Forum
Page 2 of 4
Pages: 1234