11:42:37pm, Sunday, May 05, 2024
Need help hooking up a dt360 to a 560 ih
|
Hook up
|
Need help hooking up a dt 360 into a 560 rear end |
Re: Need help hooking up a dt360 to a 560 ih
|
tools
|
Note, in the upper right hand corner of the page??
See where it says SEARCH ???????? Try that. This subject was recently beat to DEATH. Lots of good information there, we really don't need to waste more of Morgans bandwidth beating this dead horse more. |
Re: Need help hooking up a dt360 to a 560 ih
|
Registered: 04/06/2010 Posts: 139 |
tools, I don't recall any recent discussion about a DT360 in a 560. There was an informative discussion about using a 400 series. The guy asked for help, not a beat down. I haven't done this swap, so I can't help, and aparently neither can you. |
Re: Need help hooking up a dt360 to a 560 ih
|
tools
|
The back of the block is the same, the 360 is just inches shorter than the 400.
Sorry for trying to inject a modicum of common sense. Continue with the dead horse beating then, by all means! |
Re: Need help hooking up a dt360 to a 560 ih
|
kip1456
|
I agree with the beating a dead horse on here. All you guys ever post about is tractor pull this, and tractor pull that. Hell, if a guy didn't know any better, you might think that people come to this board to read about tractor pulling! |
966 adapter plate
|
Same?
|
Isn't the adapter plate the same on a 966 will bolt up dt360 to 560 rear? |
Re: 966 adapter plate
|
Anonymous User
|
Just get a 966 or 1066 backplate and bolt it up. I would get a flat flyweel and a powerstroke starter setup from Rursch |
Re: 966 adapter plate
|
Hrm?
|
Do you have to run a powerstroke flywheel and starter? And if so what r the advantages Also what kind of injectors would be the best |
Re: 966 adapter plate
|
Anonymous User
|
just the ford starter and ring gear. Depends what class I guess. Anything with some power will want a good clutch |
Re: 966 adapter plate
|
Thx
|
Oh ic what you are saying thank you |
injector questions "not beating a dead horse"
|
kole
|
hey i was wondering and did not want to beat a dead horse or anything but what would be a good injector set up on a dt360 something with a mild pump that we are building thanks and i hope i didnt cause anyone to get mad over my simple question |
Website Statistics
Global: Topics: 38,704, Posts: 229,805, Members: 3,330.
This forum: Topics: 37,081, Posts: 225,952.
Global: Topics: 38,704, Posts: 229,805, Members: 3,330.
This forum: Topics: 37,081, Posts: 225,952.
Our newest member LT Limited Pro