ring and pinion December 02, 2011 01:54PM
were the best place to contact to get the work done to put 4020 ring and pinion in a 4010 and also is it worth the money?
Reply Quote

Re: ring and pinion December 03, 2011 02:05AM
j&r machine .Salem OH
Reply Quote

Re: ring and pinion December 03, 2011 09:44AM
about any machine shop should be able to do it, i just did my own. shaft is pretty hard and it takes some time, but not too bad.
Reply Quote

Re: ring and pinion December 04, 2011 12:45PM
what all has to be done to put the 20 ring and pinion in?
Reply Quote

Re: ring and pinion December 04, 2011 02:22PM
I have done several of these. The 4020 shaft is longer so you have to make it shorter and also it has to be machined to a smaller diameter where the back bearing fits. Also on the ones I did, the splines had to be extended back a little. The grooves for the snap rings are also not in the right spot so new grooves need machined in the shaft.

I could probably do yours but I am a little backed up right now. I am building 5 whole three speed transmissions for small blocks and a couple whole three speed transmissions for big blocks. I also have a full time job so time is a little tight. If you want to talk about this my phone number is 330 5374203 and my e-mail is jimpol@embarqmail.com.
Reply Quote

Re: ring and pinion December 05, 2011 12:44AM
Jim, do you have my 8.1 head done yet,the crops are off, thanks Brad
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,766, Posts: 229,932, Members: 3,337.
This forum: Topics: 37,095, Posts: 226,025.

Our newest member DANNY.WAINSCOTT@YAHOO.COM