02:18:43pm, Tuesday, May 21, 2024
ambac model 100
|
what does it cost to get a pump done for a open rpm class, 466 cid and 3 in 3 out
also is there anything that can be tweaked on it for more power without sending it out any info would be great |
Re: ambac model 100
|
Registered: 10/21/2008 Posts: 756 |
The stock 10mm Ambac pump can be opened up and some linkage mods will help. You can change the delivery valve and shim the governor springs. It really depends on HOW MUCH HP it will take to be in the hunt where you pull. I sent both my Ambac pumps to DIS and am very happy with how they do on the track. The 13mm head has worked really well for me. IF you will at some time be allowed to switch to a in-line pump I would save my money on the rotary pump and just go to a A or P pump. Much more reliable, setable and upgradable. IMHO |
Re: ambac model 100
|
Registered: 04/30/2008 Posts: 174 |
gonna be hard pressed to keep that size turbo spinning with the best built m100 pump. you will need to be a lower gear than most ,and that will hurt you, just dont think you will be happy with that setup.high output m100 pump will set you back 1800 and up.better use an a inline or p . or go to a smaller turbo and a good m100. |
Re: ambac model 100
|
why only 13mm
|
Harts has a 14mm M100. |
Re: ambac model 100
|
Registered: 04/30/2008 Posts: 174 |
harts is not 14 mm. it is appr, 13.5 mm. and they will not put out 450 cc. aint gonna happen.very expensive and most of those have a runaway problem |
Re: ambac model 100
|
Ky hotfarm puler
|
I have a schied rototary pushing 470 cc and i think they are getting about 510cc out of there new dual feed setup. My pump was a good pump never had any problem out of mine. |
Website Statistics
Global: Topics: 38,793, Posts: 230,000, Members: 3,341.
This forum: Topics: 37,103, Posts: 226,074.
Global: Topics: 38,793, Posts: 230,000, Members: 3,341.
This forum: Topics: 37,103, Posts: 226,074.
Our newest member Jacklovik2009