11:27:10pm, Tuesday, May 14, 2024
rod length
|
Registered: 04/03/2008 Posts: 134 |
what is the difference in length between ih407 and ih466 rods? small block deere? thanks |
Re: rod length
|
Rod Length
IH 466 8.5 rods IH 407 8.75 Deere John 466 8.75 My rod... 13.75 |
Re: rod length
|
so ur a .....
|
a 2 stroker huh ??? |
Re: rod length
|
Anonymous User
|
Does anyone know what size the wristpins are on the IH 407? Also does anyone know of a any tractor or truck engines that have a rod that is about 9" long? I need some for a Hercules engine. |
Re: rod length
|
Registered: 08/21/2008 Posts: 590 |
IH 407's has two different wrist pin sizes, 1.5" and 1.625" diameter wrist pins. The 1.5" ones are easy to find, they're also the same as a D or DT361 engine. The 1.625" pin 407 rods are a lil harder to find, they were only in 1456's, early 915 High Profile combines, and UDT407 power units. Not sure what IH construction equipment that was 407 powered would have had the big pin rods. |
Re: rod length
|
Registered: 12/27/2008 Posts: 41 |
Hough payloader and Hough scraper equiped with the 407 engine. |
Re: rod length
|
Tyler Woolever
|
I am going through the same thing right now with a Herc. We are looking very hard at going to a custom rod. If you are interested give me a call at 570 337-5387 |
Re: rod length
|
Registered: 10/06/2008 Posts: 57 |
dv573 has 9.0 in rod 1.50 pin. some late rods have the 1.625 pin. only thing is the rod is a little thin. there is a cat, case and jd rod that we have also investigated that range from 9-10.2" long. good luck with your projects |
Re: rod length
|
Anonymous User
|
Thanks guys very much for the info on the rods. I want to install Caterpillar 3306 pistons in my Hercules. These have 1.500 wristpins.
Ross, I am not familiar with a dv573. Who makes it and where would I find one? Edited 1 time(s). Last edit at 02/07/2009 07:32AM by Oliver Puller. |
Re: rod length
|
Registered: 10/06/2008 Posts: 57 |
its an IH pay loader engine. I think they are about .060 thinner (roughly) on a side than a 466 IH rod |
Re: rod length
|
Another rod to try would be an IH DT429 these came in TD20 dozers. They are 9 inches center to center, 1.625 wristpin. Don't know the width. 3 inch journal. Something else would be the 540 and 640 perkins rod. They are 9 inch, 3 inch journal the wristpin is 1.750 the width I think is a little narrow. I have one in the shop I can measure. twv |
Website Statistics
Global: Topics: 38,758, Posts: 229,915, Members: 3,336.
This forum: Topics: 37,093, Posts: 226,014.
Global: Topics: 38,758, Posts: 229,915, Members: 3,336.
This forum: Topics: 37,093, Posts: 226,014.
Our newest member DANNY.WAINSCOTT@YAHOO.COM