11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 08, 2016 06:25AM
Modified Farm Pulling Rules
9,000 lbs. And 3,000 RPM Max
All rules must be met for the pulling year of 2016 or will not be allowed to participate.

1. 1.3000 RPM Max. RPM pickup required with lead wire installed externally upon the frame of the tractor. Lead wire must be without breaks or connections between pick up and 3 pin connector. 3 pin connector need to be mounted on the rear of the tractor at an easily accessible location.
2. Safety Equipment-
• Wheelie bars to be securely mounted to the rear of the tractor
• Tie bars - recommended
• Safety blanket or Clutch housing scatter Shield
• Steel flywheel - recommended, but not required
Dead man throttle required
• Air shut off located at the back of the tractor
• Must have fenders
Roll bar or roll cage required (MUST wear helmet with cage)
• Cross bolts mounted in exhaust pipe – 2, 3/8 grade 8 bolts
Seat belt
• Side shields constructed of minimum 0.060 material
• Mechanical Fuel shut off valve (Ball Valve) or 3-way Dump Valve.
3. 12-15MPH pace. This class will have a pace drawn from a hat by the first puller of the class. All speeds will be used before speeds are returned to the hat. Example – If at the Cuba City pull the first puller draws 12MPH the class will be 12MPH. The next pull the first puller of the class will choose a speed from the hat from 13, 14, or 15MPH. If the puller chooses 14MPH the third pull using these rules will allow the first puller of the class to choose from the hat containing the speeds 13 or 15MPH. NO GRACE OR BUMP OF SPEED LIMIT
9a.If the promoting location chooses to have a second Modified Farm class; the promoter may choose to use another speed from the hat or a speed of their choice if any.
4. Weight limit will be 9,000 lbs.
5. OEM manifolds. Intercoolers will be allowed, but only using an OEM manifold and running engine fluids. NO ICE BOXES! Example- if an IH chooses to install an intercooler off a DT bus engine or equivalent that was an IH part number this will be allowed but no aftermarket intercoolers or headers.
6. Turbo/Super Charger limited to one
7. Cubic inch limited to 540 cubic inch with factory components
8. Limited to an A pump except if the application comes stock with P pump
9. No Electronic throttle/engine/traction controls
10. Water injection is allowed using water only. Location and number of nozzles for injection is not restricted
11. Tire size limited to 18.4 – 38. No Altered tires allowed
12. Limited to One fuel only
13. Drivers must be at least 14 years of age with driving certificate and parental consent
14. On Board fire extinguisher recommended
15. All other general tractor pulling rules and common sense apply.


Too hot to Farm Tractor Pulling Rules
11,500#s and 3,000RPM max
All rules must be met for the pulling year of 2016 or will not be allowed to participate.

1. 3000 RPM Max. RPM pickup required with lead wire installed externally upon the frame of the tractor. Lead wire must be without breaks or connections between pick up and 3 pin connector. 3 pin connector need to be mounted on the rear of the tractor at an easily accessible location.
2. Safety Equipment-
• Wheelie bars to be securely mounted to the rear of the tractor
• Tie bars – recommended
• Safety blanket or Clutch housing scatter Shield
• Steel flywheel - recommended, but not required
Dead man throttle required
• Air shut off located at the rear of the tractor
• Must have fenders
Roll bar or roll cage required (MUST wear helmet with cage)
• Cross bolts mounted in exhaust pipe (2- 3/8 grade 8 bolts within 1” of each other)
Seat belt
• Side shields to cover engine compartment. Constructed of Minimum .060" steel.
• Mechanical Fuel Shut off valve (Ball Valve) or 3-way Dump Valve installed before injection pump
3. 15-18MPH pace. This class will have a pace drawn from a hat by the first puller of the class. All speeds will be used before speeds are returned to the hat. Example – If at the Cuba City pull the first puller draws 16MPH the class will be 16MPH. The next pull the first puller of the class will choose a speed from the hat from 15, 17, or 18MPH. If the puller chooses 18MPH the third pull using these rules will allow the first puller of the class to choose from the hat containing the speeds 15 or 17MPH. NO GRACE OR BUMP OF SPEED LIMIT
3a. If the promoting location chooses to have a second too hot to farm class; the promoter may choose to use another speed from the hat or a speed of their choice if any.
4. 11,500# will be the weight of the class at all locations
4a. If the promoting location chooses to have a second too hot to farm class; and wants a different weight they may choose +/- 500# of the original 11,500# class. Example the second class could be 11,000# or 12,000#.
5. OEM manifolds. Intercoolers will be allowed, but only using an OEM manifold and running engine fluids. NO ICE BOXES! Example- if an IH chooses to install an intercooler off a DT bus engine or equivalent that was an IH part number this will be allowed but no aftermarket intercoolers or headers.
6. Turbo/Super Charger limited to one
7. Cubic inch limited to 540 cubic inch with factory components. (Head/block/etc.)
8. Tractor must be equipped with a Wide Front Axle
9. No Electronic throttle/engine/traction controls
10. Water injection is allowed using water only. Location and number of nozzles for injection is not restricted
11. Tires will be limited to 20.8R38 or 18.4R42 tires. No Altered tires will be allowed
12. Tractor is limited to one type of fuel(Propane, gas, diesel)
13. On Board fire extinguisher recommended
14. All other general tractor pulling rules and common sense apply.
15. Drivers must be at least 14 years of age with tractor driving certificate and parental consent.

Updates in Bold

Thank you
Mueller 608-732-0653

Southwest Wisconsin Farm Tractor Pulling Rules January 08, 2016 06:37AM
Southwest Wisconsin Farm Tractor Pulling Rules

General Farm Tractor pulling rules

1. Rubber tires only. No chains,duals,4x4, or studs Permitted
2. All minors must be 14yr of age with written consent from guardian and have tractor driving certificate.
3. Tractor must have standard block and crankcase
4. Tractors must have original injection pump and if equipped with a blower. It must have factor stock number and no visible modifications.
5. All weight must be safely secured to tractor. Any ballast or external part lost while hooked to sled under green flag will result in a disqualification.
6. Tractor must have workable rear brakes.
7. Tractor must have working PTO and Hydraulics.
8. Drawbar is to be stationary in all directions while hooked to sled and pulling. Maximum height of 20 Inches from top of hitching device parallel to ground. Drawbar must have a opening of 3.5 inches and at leased a 6 inch clearance from all weights!
9. No one allowed on track except for track officials and contestants.
10. Any portion of the tractor going out of bounds will result in a disqualification.
11. First puller of the class must use the pull.
12. One fuel only is permitted. Tractor must use stock fuel for make and model of tractor. Gasoline, diesel, or propane are considered primary stock fuels. Ether, Oxygen, Alcohol, and various forms of Nitromethane are not allowed!
13. All exhaust must be discharged vertically upward with a minimum exhaust height of 12 inches.
14. No bounce or grace of set speed limits(10mph means 10.0 from the moment you begin forward progress)
15. Tractors are given 100ft to shut down and restart their pull
• NO UPSHIFTING WILL BE PERMITTED PAST 100FT IN FARM CLASSES

Non Turbo Farm Tractor

1. 18.4R38 uncut tires or smaller; unless factory equipped with wider tire in which competitor must use be using factor cast wheels.
2. 3000 RPM maximum
3. Weight at the discretion of the promoter
4. 8 MPH or less at the discretion of the promoter.


Turbo Farm Tractor

1. 20.8R38 or 18.4R42 uncut tires or smaller; unless factory equipped with wider tire in which competitor must use be using factor cast wheels.
2. 3000 RPM maximum
3. Weight at the discretion of the promoter
4. Non-altered turbos. No slots, Slugs, Billet wheels, or waste gates are allowed.
5. 12 MPH or less at the discretion of the promoter.


N/A Hot Stock Tractor

1. 18.4R38 cut tires
2. Open RPMs w/ safety equipment
3. 6000-6500#s will be the weight of the class by discretion of promoter.
4. Up Draft Carburetors only
5. Gas, Propane, or Diesel Fuel only. No Alcohol
6. No turbos
7. Adequate safety equipment required


466CI Hot Stock Tractors

1. 20.8R38 cut tires
2. Open RPMs w/ Safety equipment
3. 9500#s will be the weight of the class by discretion of promoter
4. Single fuel only
5. Adequate safety equipment required

Re: 11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 08, 2016 09:55AM
Should have ROPS, frame rails and 800 horse by Cuba City.


Re: 11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 08, 2016 11:19AM
we have one already built just add cage and turbo

Re: 11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 08, 2016 11:27AM
now that is some good looking red!

Re: 11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 08, 2016 02:33PM
Wyatt what are your plans with the natural born thriller

Re: 11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 09, 2016 12:02PM
Sure glad I found out that piece of scrap iron to pull 2 hot with.

Re: 11,500 Too Hot To Farm and 9,000 Modified Farm Updates for 2016 January 10, 2016 01:14PM
Heard it's getting retired for auger duty running a 16" auger north of Alburnett.

Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,718, Posts: 229,834, Members: 3,330.
This forum: Topics: 37,083, Posts: 225,968.

Our newest member LT Limited Pro