does anyone know if u can take a small pin 407 rod and make it a big pin March 02, 2013 01:27PM
does any one know if u can take a set of small pin 407 rods and make them a big pin?
Reply Quote

Re: does anyone know if u can take a small pin 407 rod and make it a big pin March 03, 2013 01:22AM
In my opinion, it can be done. Whether or not you will be successful with it depends a lot on horsepower. A much better alternative for you would be to switch over to a John Deere rod. It is the same length as the IH 407 rod and would be 100% better than taking even more material out of the piston pin area on a 407 rod. I have a set of deere rods that would work perfectly for you that are already machined and clearanced for the IH crank. They are fitted with standard bearings as well. Ready to install for $1000. If interested, call or text me @ 608-317-7321
Reply Quote

Re: does anyone know if u can take a small pin 407 rod and make it a big pin March 03, 2013 04:48AM
You remove the bushing and pin hone the rod end and run it without a bushing. Works fine
Reply Quote

Re: does anyone know if u can take a small pin 407 rod and make it a big pin March 03, 2013 06:09AM
it doesnt wear or anything?
Reply Quote

Re: does anyone know if u can take a small pin 407 rod and make it a big pin March 03, 2013 06:10AM
im putting this in a 1200 hp motor and how long will it last?
Reply Quote

Re: does anyone know if u can take a small pin 407 rod and make it a big pin March 03, 2013 06:46AM
There is the same amount of material in a small pin 407 rod as there is in a large pin.
Reply Quote

Re: does anyone know if u can take a small pin 407 rod and make it a big pin March 03, 2013 01:35PM
i am building a 361 on alcohol for the llss does anyone no of a longer rod that would work to get rid of the tall pin hieth on the piston plans are 41/8 stroke 43/8 bore the rod journel could be a lot smaller to make destroking a lot cheaper any help would be appreciated had deutze rods in my cummins thanks
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,731, Posts: 229,864, Members: 3,332.
This forum: Topics: 37,086, Posts: 225,984.

Our newest member WestonFarms