Case 504 NA December 30, 2013 02:08PM
I'm working on a 504 NA motor and looking for advice from anyone with experience building one for a NA puller. I'm going to be running 2800-3000 rpm depending on the pull. I'm using a donor motor from a 1370 as my starting point. Right now I'm having a hard time finding info on making a cam swap and other ways to add power. Anyone out there that can point me in the right direction?
Reply Quote

Re: Case 504 NA December 30, 2013 02:28PM
You will need to get some higher compression pistons such as a 870 as your ratio is about 15.8 to1 with the turbo engine and a N.A. piston is 16.5 to 1,might be hard to get much over 150 HP
Reply Quote

Re: Case 504 NA December 31, 2013 05:13AM
Case800 sent you a PM.
Reply Quote

Re: Case 504 NA December 31, 2013 08:01AM
Rdl do u no the compression ratio of a 451 non turbo and a turbo
Reply Quote

Re: Case 504 NA December 31, 2013 08:41AM
Service book shows them both at 16.5 to 1
Reply Quote

Re: Case 504 NA January 04, 2014 10:35AM
Voguls in effingham reground my cam for my 585minn i am building for a N/A and dennys carb shop reserfaced my lifters Vogules also made me a set of pistons to up my compression but i was faced with AGCO pistons costing the same so it was a no brainer plus go as big as you can legal run the pistons wont cost any more if you have some made
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,779, Posts: 229,954, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,037.

Our newest member Jacklovik2009