04:38:08am, Wednesday, May 15, 2024
Water idiot light
|
Puller 29999333
|
What are you guys using for the idiot light sensor to know the water inj turned on? I was running a sensor from napa for low oil pressure on a car but it keeps blowing apart under inj pressure. Thanks Edited 1 time(s). Last edit at 07/01/2014 02:23AM by MH49. |
Re: Water idiot light
|
Registered: 09/17/2008 Posts: 157 |
I got mine from Zoro tools. Just put it on tho, so not sure if it will hold up either |
Re: Water idiot light
|
Case
|
Use a case 1840-1845 back up light sensor. That will only show you on not off like the one Simpson sells. They are both nason brand or order one that has has a n/o and n/c so you have an on and off light. |
Re: Water idiot light
|
simple
|
I'm using a pressure switch to turn water on at a desired boost pressure. And I have a indicator light wired to the same pressure switch. |
Re: Water idiot light
|
mx335
|
Exactly as simple said works perfect |
Re: Water idiot light
|
brands
|
Do you have a brand of switch, a part number, or the place to get this switch? |
Re: Water idiot light
|
MLC
|
www.mcmaster.com - look up presure switch then take your pick |
Re: Water idiot light
|
Burnt piston
|
The bad thing about wiring right to the pump switch if you do run a 12v system is do you have water pressure. That's why most would have two switches so you know there is water pressure in the line. |
Re: Water idiot light
|
pressure switch
|
Any type of pressure switch. Grainger |
Re: Water idiot light
|
Ebel
|
Wire it to the same switch you youse to turn on water |
Re: Water idiot light
|
I used a nitrous switch from summit racing works good you can adjust to your selected pressure |
Re: Water idiot light
|
what I've learned
|
You have to be careful with pressure selection when the switch is installed in the water injection manifold or line. I had my switch into a manifold that my lines came out of. Boost would back feed into the water injection nozzles and pressurize the manifold making the switch to close and trip the light. |
is this the switch # your using?
|
ABH
|
Nitrous Express # 15943 from summit or Jegs for $135? Did you put it on a Simpson water setup? What does a Simpson water setup run for PSI? How long has switch lasted? |
Re: is this the switch # your using?
|
Cant recall part number i just asked for a adjustable nitrous switch . i had it on a 12 volt hydralic pump and it worked great never had any issue with it and it lasted 4 seasons, when i sold the tractor it was still on it. |
Re: Water idiot light
|
scott potter
|
A/C pressure switch from parts store. less than 10 bucks take your pick on pressure 12 volt to one side put light on other. ( get a normally open switch) |
Website Statistics
Global: Topics: 38,758, Posts: 229,915, Members: 3,336.
This forum: Topics: 37,093, Posts: 226,014.
Global: Topics: 38,758, Posts: 229,915, Members: 3,336.
This forum: Topics: 37,093, Posts: 226,014.
Our newest member DANNY.WAINSCOTT@YAHOO.COM