Fire Ring Info Needed December 03, 2018 05:43AM
I just took the head off a pulling tractor that I bought....It seemed like the fire rings sit quite a ways from the sleeves...How close should they be to the edge of the sleeves? Should I order ones at least .040 bigger ID than the sleeve groove to allow plenty of crush room..The crushed fire rings measured .090 thick so that was .015 crush on .105 rings...I would assume that .015 or .020 crush is enough to hold things..

Re: Fire Ring Info Needed December 03, 2018 09:29AM
Best bet is to call seal tech and they’ll tell you everything you need to know. (630) 692-0633

Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,779, Posts: 229,957, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,040.

Our newest member Jacklovik2009