08:32:29pm, Saturday, May 18, 2024
4430 input shaft/gear
|
Registered: 02/08/2014 Posts: 406 |
Does anyone make/sell a billet transmission input shaft (the hollow one) and gear for a 4430 ? Trying to stay with the wet clutch setup. Thanks for any info. |
Re: 4430 input shaft/gear
|
Been there
|
Would this happen to be the same tractor that broke something at Lorah’s Saturday night?
What gear ended up breaking? To be honest you might be fighting a losing battle. Anything could be made, but at what cost. |
Re: 4430 input shaft/gear
|
Registered: 02/08/2014 Posts: 406 |
Yep. The first gear on the shaft and the shaft then it dropped parts down and took a tooth off the bottom gear.. Not positive on which broke 1st. If we can get something made it would still be less expense than a dry clutch setup I think. Maybe next time it gets a different setup. Sure is a job to change it. There was a 4430 with the picture of a buck on the side panel which used to pull at Hughesville Pa. that had issues with a shaft breaking a lot. I would like to know who it was. I haven't seen the tractor pull in a few years. |
Re: 4430 input shaft/gear
|
My 2 cents for what it worth just spend on a 3 speed and dry clutch be cheaper in the long run. Your making power from what I seen at pig farm and fighting a losing battle with wet clutch and stock trans |
Re: 4430 input shaft/gear
|
Registered: 02/08/2014 Posts: 406 |
I agree. A good winter project. Going to try it again as is for now. With our fingers and toes crossed. Thanks for the input. |
Website Statistics
Global: Topics: 38,779, Posts: 229,954, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,037.
Global: Topics: 38,779, Posts: 229,954, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,037.
Our newest member Jacklovik2009