Viroqua Pull Sept.19 September 12, 2020 12:17PM
Pull is located at the Vernon County Fair Grounds in Viroqua,Wi right off Hwy.14. Saturday September 19,2020

11 am session
4500 farm
5500 farm
5500 open antique
5500 improved antique
9500 na/farm
12,500 farm
6500 Out Law 20mph South West Puller Rules
9000 2-Hot-2 Farm SWP Rules
11,000 Altered Farm SWP Rules $1000 added prize money
** 2.6 Diesel Trucks** SHOOTOUT top 6 trucks pull pull off during the 6pm session. $500 to the winner
Info on 11 am session call Erik Vesbach @ 608-606-1011
Pullers please be on the grounds and registered by 10:30am or call ahead to get registered.
This session will be broadcast on Vernon CO-OP channel 14.We will be pulling at 11.


6pm session

12,000 2-Hot-2 Farm ECI Rules
9500 Hot Farm (3 x 3) turbo
9300 Super Farm
9500 4.1 Lim Pro
8500 Light Pro
6500 open (OPEN MEANS OPEN)
Light Super Stock/ Diesel Super Stock (we'll work the weights out between the pullers before the show starts. Due to covid!!!!!)
2.6 Diesel Truck Finals
Semi Trucks
Pullers please be registered by 5:30 or call ahead. 12,000 2-Hot-2 Farm will be the 1st class. please be weighed and lined up by 5:30. Drivers meeting at 5:30.
This session will be recorded for future broadcasts. We are expecting a "fairly" good turn out and will need to keep things moving along!

Info call Chris Leer 608-632-0236 or Jeff Parr 608-632-4020

See Viroqua Area Pullers LLC Facebook Page or Beer Money Facebook Page for OFFICIAL UPDATES

Re: Viroqua Pull Sept.19 September 13, 2020 08:52AM
If you plan on attending the Viroqua Tractor Pull this coming Saturday Night, September 19, 2020, please visit the Viroqua Area Pullers Facebook page and print off the Puller Profile Sheet and bring it with you. Hope to see everyone there!

Re: Viroqua Pull Sept.19 September 16, 2020 08:21AM
Reminder and update:
We are asking only Pullers to enter the North Gate of the fairgrounds to the infield and pits.

The infield will be divided in two. We are asking the 11:00 am session pullers to PLEASE park on the west (right) side of the infield and the 6:00 pm session to park on the east (left) side. We may have a guy with a loader and bale forks to assist you if you happen to park on the wrong side!

Please print off one of our entry forms and have it filled out to help speed up registration.

Registration will close at 10:30 for the 11:00 am session.PLEASE call ahead if you are running late to Register. Jeff 608-632-4020 Chris 608-632-0236 Erik 608-606-1011 Penny 612-202-9933

Entry will close at 5:00 pm for the 6:00 pm session. And the 6pm session will actually start at 5:30 with the 2-Hot-2 Farm class.

Drivers meeting at 10:30 am and 5:00 pm.

We are expecting a fairly good turn out and will need to keep things moving along. We will have people helping with line ups. All open classes will need safety equipment, please have the fire suits on and helmets on before pulling on the track.

Have a good time, bring your own beer and we are suppose to tell you to follow the CDC recommendation stuff!!

ATTENTION 2.6 TRUCKS September 16, 2020 02:52PM
Attention 2.6 TRUCKS
Thanks to a sponsor stepping forward it now will be $1000 to the winner of the 6 trucks advancing to Saturday night.

6500 Outlaw rules September 16, 2020 10:09PM
20 MPH Pace

18.4x38 Max Tractor Tire Size 2WD and 4WD trucks, 35” max DOT approved tire size.

Tractors have a 20” max drawbar height and an 18” minimum length from the center of the rear ax
Trucks have a maximum drawbar height of 26”

Single Fuel only allowed: Alcohol, Diesel, Gasoline and Propane.

Turbochargers are allowed.

Vehicle must have a 2.5 # fire extinguisher mounted within reach of the driver.

Seat must have a back and lap seat belt.

Roll Cage or ROPS are Highly Recommended.

Tractors are to have a wide front end.

Must have Side shields and Electric fans

Must have a shield around harmonic balancer.

Steel Flywheel is required.

Must have scatter shield or blanket around clutch and flywheel.

Tie bards extending from rear axle housing to main frame.

Wheelie bars, Max 10” cut off the ground required.

Deadman Throttle

Fenders and floorboard that support full weight of driver.

Kill Switch mounted of the rear of the vehicle, are shut off for the diesels and electrical shut off for the spark fired engines is required.

9000 To Hot To Farm rules September 17, 2020 12:30PM
Fireproof Jacket, Pants and Helmet are Required to be worn while hooked to sled.

Must have Weld on Hubs for Pressed Steel. No Cast Centers.

3,000 RPM Max. Tractors will be checked at each pull. Must have RPM sensor with plug in at rear of Tractor to hook to the sled.

Speed Limit of 17 MPH

Weight Limit of 9000 lbs.

Required Equipment OEM Ag rear end.

Drawbar must be a minimum of 18” from center of rear axle.

Drawbar Maximum Height of 20” Stationary in all directions.

Maximum Wheelbase of 114”

Maximum Frame length from center of rear axle 156”

Working Brakes

Must have Fenders.

Maximum Tire size of 18.4-38 TOP CUT ONLY(NO CUT ON FACE OF LUG)

Clutch Blanket if tractor has a Cast Iron Flywheel.

Stabilizer bars. Pads to be nor high than 10” from the ground. Pads must extend beyond the radius of the tire.

Air Kill switch. Must be spring loaded. With activating cable mounted at the rear of the tractor in clear sight to hook to the sled.

Dead man Throttle (must return to idle when released)

Turbo must be under Hood

Side Shields

Wide Front End

Cross Bolts mounted in exhaust pipe, 2 3/8” grade 8 bolts.

Tie bars mounted to the rear axle and extending forward of the flywheel and mounted to the frame.

Fuel dump valve able to be controlled from seat. (Recommended)

Roll Bar or Roll Cage

Seatbelt

Front Ski Bars, in line with the frame rails. Pads to be below front wheel hubs. (Recommended)

540 Cubic Inch limit

Stock OEM Manifolds

May run a stock intercooler. NO Icebox
.
May Use Water Injection, Water only.

Diesel Fuel Only

Drivers must be at least 14 years of age with driving certificate and parental consent to compete in
the class.

Re: 11,000 Altered Farm rules two days ago
Pullers are required to wear full fireproof Jacket, Pants and Helmet.

11,000lbs

OEM Motor and Block. Block is not to be altered in any way externally for mounting of fuel injection pumps and remain in stock location.

Internal webbing and water jacket to remain intact with provisions to re-bore block.

OEM Transmission must be stock appearing. No aftermarket gear boxes,. Clutch housing, transmission case, rear end housing must be OEM or equivalent.

Custom Frames and tube chassis are allowed. Must meet Tech and Class rep approval.

Must have OEM cylinder head, intake manifold and exhaust manifold for that model or series tractor. No filler heads, single feed intake manifolds only.

No headers or custom intakes manifolds. 1 inch intake manifold spacer allowed.

505 Cubic inch limit. Under 470 may alter the bore and stroke of the engine to a max of 470 cubic inch.

Exceptions: Massey Ferguson 540, Cockshutt, Oliver and White 585. They must retain factory bore and stroke.

P-Pump: P7100 Max

Wheelbase is a maximum of 114 inches unless produced by manufacture. Maximum of 13 feet from the center of the rear axle to the forward most part.

Full Sheet metal to be in stock location and appearance. Including Hood and grill.

Must have a wide front end. Will be subject to inspection and Southwest Pullers approval.

Max of 2.4” S300SX-E turbo allowed

No injectables allowed. Water injection is allowed: Max of 2 ports in crossover pipe
.
Crossover pipe to be no more than 3.25” diameter.

Turbo must be sealed by FVP.

3000 RPM max.

No intercoolers or cooling devices allowed.

12,000 2-Hot-2 Farm ECI Rules two days ago
Page 31

[www.ecipa.net]

Todays times,pit parking and contact numbers yesterday, 12:08AM
11:00 am session pullers to PLEASE park on the west (right) side of the infield and the 6:00 pm session to park on the east (left) side.

Please print off one of our entry forms and have it filled out to help speed up registration.

Registration will close at 10:30 for the 11:00 am session.

PLEASE call ahead if you are running late to Register. Jeff 608-632-4020 Chris 608-632-0236 Erik 608-606-1011 Penny 612-202-9933

Entry will close at 5:00 pm for the 6:00 pm session. And the 6pm session will actually start at 5:30 with the 2-Hot-2 Farm class.

Drivers meeting at 10:30 am and 5:00 pm.

We are expecting a fairly good turn out and will need to keep things moving along. We will have people helping with line ups. All open classes will need safety equipment, please have the fire suits on and helmets on before pulling on the track.

Have a good time, bring your own beer and we are suppose to tell you to follow the CDC recommendation stuff!!

Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 34,492, Posts: 199,647, Members: 4,781.
This forum: Topics: 33,079, Posts: 198,225.

Our newest member wallacemichels7