05:20:23am, Saturday, May 04, 2024
IH ring and pinion for 540 class
|
overload
|
Which ring and pinion would be best for a 540 single 3x4 charger on IH 1066 . |
Re: IH ring and pinion for 540 class
|
gear ih head
|
13/49 3.769 then 2 or 3 teeth over direct
16/49 3.062 then direct or 1 tooth under direct..............maybe |
Re: IH ring and pinion for 540 class
|
overload
|
Seems a little fast but you might be right. Eventually will put on a bigger charger so 13/49 might be a good match. How much slower would 13/51 be in direct . Too slow?? Is direct in 13/49 about 20-21:1. |
Re: IH ring and pinion for 540 class
|
newbie
|
Not to sound too dumb but what do your gear ratios mean? 17:1 vs a 21:1, which is a bigger gear. trying to learn |
Re: IH ring and pinion for 540 class
|
overload
|
input shafts turns 21 times when the rear tire makes one revolution thus 21:1 is a slower gear than 17:1 |
Re: IH ring and pinion for 540 class
|
Anonymous User
|
The easy way to explain this is that for a 17:1, the output shaft in the tranny has to spin 17 times to turn the axles one revolution. For a 21:1, it is 21 revolutions and so on. So in this case, 17:1 is faster than 21:1 because the output shaft has to make less revolutions to turn the axles one revolution.
Edit: Sorry for the double post Edited 1 time(s). Last edit at 04/12/2010 07:15AM by Elderly Deere. |
Re: IH ring and pinion for 540 class
|
gear ih head
|
the 13/51 is 22.029 final drive in direct, it's about 4% slower than 13/49.
It depends on what weight class you will be pulling, and also what tire size. |
Re: IH ring and pinion for 540 class
|
overload
|
8500 and 24.5 double cuts |
Re: IH ring and pinion for 540 class
|
gear ih head
|
if your 540 engine is making good power it shouldn't be a problem pulling 13/49 in direct, down in ky there are several 3x4 hot air 466's running that ring & pinion @ 8500 and spin out hard at the end. |
Re: IH ring and pinion for 540 class
|
overload
|
What type of tracks do you have. I've got about 1150 horses but pull on some tough clay tracks |
Re: IH ring and pinion for 540 class
|
gear ih head
|
with that peak hp if your making approx. 2100 ft. lbs somewhere in the mid 2000's (2200-2500) rpm you will be fine, if your not quite there you prob. need the 13/51 |
Website Statistics
Global: Topics: 38,687, Posts: 229,792, Members: 3,328.
This forum: Topics: 37,080, Posts: 225,955.
Global: Topics: 38,687, Posts: 229,792, Members: 3,328.
This forum: Topics: 37,080, Posts: 225,955.
Our newest member Jason