IH 466 sleeves fit into 414 block September 02, 2010 01:03PM
What is involved with getting IH 466 sleeves to fit into the 414 block?
Reply Quote

Re: IH 466 sleeves fit into 414 block September 02, 2010 01:10PM
They are the same dimensions and will go right in or you can use the 414 sleeves. Only thing different is the pistons and crank.
Reply Quote

Re: IH 466 sleeves fit into 414 block September 02, 2010 01:11PM
Their the same! Only difference is stroke between the two, otherwise the bore is the same.
Reply Quote

Re: IH 466 sleeves fit into 414 block September 03, 2010 07:23AM
So, if the sleeves are the same (length, width, inside diameter, outside, etc...) all you have to do is change the Crank? That will add to the stroke, in turn increasing cubic inches? Or do you have to change rods and pistons as well? Thank you.
Reply Quote

Re: IH 466 sleeves fit into 414 block September 03, 2010 07:48AM
Just change the crank and pistons. The pin height is different on the pistons from the 414, 436, and 466. Or you can shave your 414 pictons, cut whatever off the top. But then you need to remachine the bowl too. Hyper used to machine the 414 pistons for like $60 each..
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,777, Posts: 229,948, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,033.

Our newest member Jacklovik2009