06:28:17am, Thursday, May 16, 2024
Oil Cooler JD 466
|
Registered: 01/20/2010 Posts: 42 |
I need to remove the oil cooler on a JD 466 to make some room. Can I just make two plates and block off the passages? Or does the oil need to circulate or anything special I need to do? |
Re: Oil Cooler JD 466
|
which
|
factory or external pump ? Crank or cam driven? |
Re: Oil Cooler JD 466
|
Registered: 01/20/2010 Posts: 42 |
Cam driven factory pump. |
Re: Oil Cooler JD 466
|
which
|
Ours is an external pump & we took all the plumbing out inside the pan, but if everything is intact it should just
bypass the cooler if the bottom is plated off. If you prefer a short loop could be made using the 2 holes in the block that wouldn't take much room, & the oil would flow normally. I'd be leary of pushing that cam drive oil pump too hard though. |
Website Statistics
Global: Topics: 38,766, Posts: 229,932, Members: 3,337.
This forum: Topics: 37,095, Posts: 226,025.
Global: Topics: 38,766, Posts: 229,932, Members: 3,337.
This forum: Topics: 37,095, Posts: 226,025.
Our newest member DANNY.WAINSCOTT@YAHOO.COM