Page 1 of 1 Pages: 1
Results 1 - 11 of 11
someone school me on Franklin planetaries,
Is there an old style and a new style?
What machines can they be found on
Is the 4.6 ratio factory option on some machines or purely aftermarket
Can the older steel housings be drilled to accept the alluminum covers that have the ring of bolts instead of just the 3 bolts that the steel cover has, if so is there an advantage to doing this or just for
by
WhiteLightnin
-
Forum
Need to sharpen my 30.5 puller 2000’s, what’s the latest and greatest for dressing up the edges, hot knife and grinder? and where is the best place to get discs from? I would love to send them to the states to one of the pros but by the time I pay shipping might as well just buy new ones, thanks
by
WhiteLightnin
-
Forum
Anyone had any hassle from DOT for not using Elogs in your tractor trailer ? Whats the workaround for it? Private not for hire stickers or?
by
WhiteLightnin
-
Forum
Good job driving on her part, out of the throttle and didnt stab the brakes, sure it ended up rolling but could have got real ugly
by
WhiteLightnin
-
Forum
Looking for a set of 10 foot long aluminum ramps for my new trailer, does anyone use a 16” wide ramp on 30.5 tire or does it dig in too much? Have trouble finding anything wider than 16. Thanks
by
WhiteLightnin
-
Forum
Can someone tell me the standard franklin planetary bolt pattern and wheel center hole size?
by
WhiteLightnin
-
Forum
With only 2 super mod tractors and a limited number of pulls around here the boys like to finish the show so that the fans remember, most times we only get 1 pull per year in these small communities and like to leave a lasting impression. I do agree there shouldn't have been any fans at the end of the track, and that groomer shouldn't have been hanging out down there but you can rest a
by
WhiteLightnin
-
Forum
I usually use the 148347-C1 weights, a deal came up on some 383393R1 weights, just wondering if anybody has hung them side by side and if they are close to same look or completely oddball, wants 400$ for 10 of them so kind of hard to go wrong as long as they will hang on the same bracket
by
WhiteLightnin
-
Forum
Does anyone have torque specs for aluminum rockwell pr75's, looking for specs for the main spindle nut and the planet gear housing, thanks
by
WhiteLightnin
-
Forum
Looking for advice on a custom grind cam for a blown 540 for a single engine mod, was going to go with comp cams but tired of waiting for a call back, any other suggestions?
by
WhiteLightnin
-
Forum
Whats available for misalignment couplers to work with the 55's input spline?
by
WhiteLightnin
-
Forum