Page 1 of 1 Pages: 1
Results 1 - 7 of 7
Does anyone know of a standard screw on oil filter that is 1"- 12 thread, around 30 micron and at least 30 gpm.. So far I have not come up with anything.. May not be even a filter to these spec's.. May have to go to a remote system, But thought I would give this a shot first.. Thanks
by
gatechaser
-
Forum
If you want to sell your 8" orberg let me know.. Thanks Shawn 573-406-5490
by
gatechaser
-
Forum
Does anyone out there make a high flow air cleaner set up (under the hood) for a IH 1066 4.1 LPS tractor. Thanks.
by
gatechaser
-
Forum
Thanks for all the reply's. I was thinking fuel pressure, but was need support to back my thoughts up.
by
gatechaser
-
Forum
I'm running a IH in the 4.1 class. 640 inch with a 13mm pump that is turned up as far as I dare. I use 4 qt of water in a pass and the cylinder temps are around 1320 straight down the line. Fuel pressure going down the track is around 30 to 35. Tractor is running good.
My Concern. The farther i get down the track, the whiter my smoke gets. Doesn't seem wright to me, but asking for opin
by
gatechaser
-
Forum
Thanks to everyone who reply. You gave me Good direction.
by
gatechaser
-
Forum
Could someone tell me what's the best type of foam to use in a rearend that is oil resistant. I only want to run about 4 or 5 gal and I want to contain it to the back half of the housing. Thanks.
by
gatechaser
-
Forum