Page 1 of 1 Pages: 1
Results 1 - 13 of 13
Need to purchase a new clutch assembly for my Chevy 4wd truck, 800hp. 6 1/2 inch depth Lakewood can. Been using a Mcleod 2 disk. Looking for recommendations/opinions/reviews on what others are using. Thanks in advance.
by
pss1175
-
Forum
Thanks guys. Yes we are limited to 1 ton drivetrain. They call this a street stock class but everyone trailers them in and they are all over 800 horses. I was going to put a 106 in but not allowed. It's BS I know but that is how it is. Thanks again.
by
pss1175
-
Forum
I am building a 4wd puller. Will be 900 horse and 6200lbs. My question is will a dana 60 and 14 bolt rear take the power? What if they are cryogenic treated? Thanks
by
pss1175
-
Forum
Add the electric water pump and use a gas powered leaf blower after the run.
by
pss1175
-
Forum
My suggestion is to read the reply from Bullet fan, wayne s and ol George carefully. They are offering very good advice. There is ALOT to consider BEFORE you start buying parts or complete tractors. Take your time, think it through. If a deal seems to good to be true, IT IS! There are alot of people in pulling that will take advantage of you.
by
pss1175
-
Forum
You are going to have a very tough time building any pulling vehicle for 10K. What organization are you planning on running with? Do you want a tractor or truck? I know you can build a street stock or altered stock 4x4 for 10-15K. Garden tractors are going to run you over 10K.
by
pss1175
-
Forum
I ran an 1175 for 3 years but I removed the power shift. Had a 3 disk Crower. Also ran 5 hole .025 bosch injectors with a p series pump set around 650cc. I was 504ci with a bone stock cam and a 3LM. Timing was 36 degrees. Made 72 psi intake boost at 5000rpm's and it ran like a raped ape.
by
pss1175
-
Forum
How many cubes, stock cam? Compression?
by
pss1175
-
Forum
How much and where is it at?
by
pss1175
-
Forum
I am looking for someone to build a 370ci blown and injected SBC. Does anyone know of a reputable builder in the midwest?
by
pss1175
-
Forum
It is a new chassis, mild steel not moly. No gear box. Firestone tires, aluminum wheels, steering, seat, harness, no fuel tank. It will be for state level pulling with a blown small block.
by
pss1175
-
Forum
Can someone tell me what a rolling mini chassis cost? Looking for one that I can drop my motor and trans in and go, preferably a wysong or TRB. I have local shop trying to sell me one for $17,000, that seems a little high. Am I wrong?
by
pss1175
-
Forum
Call Phil at Riverside engines in Tiffin, Ohio. He will set you up with everything you need. I used the largest single stage Aviaid pump available. Saw alot of Pro stockers using the system I bought. I put many seasons on my Super Farm before i changed any bearings. Ran 60-70 psi. I believe it cost about $1700.00 for everything including AN fittings and stainless steel braided lines. Riversides
by
pss1175
-
Forum