Page 2 of 2
Pages: 12
Results 31 - 40 of 40
I was wandering if anyone has put a electric mechanizism on a quad range 2 speed linkage for shifting? If so what did u use? Just trying to free up the right hand a little.
by
risky
-
Forum
I was wanderin where I might find a place that could make a set of side shields
by
risky
-
Forum
Yes the rails have to be stretched an hood also. It's not all that bad , just need some donor parts to work with.
by
risky
-
Forum
Can helm pump be hooked into factory steering lines to turn the factory steering system
by
risky
-
Forum
Ok thanks, An what shaft u talking about leaving in for support
by
risky
-
Forum
Well it was a last min deal an all I done was tied up pto lever but have got it all apart now an goin to fix lube valve.
by
risky
-
Forum
The main clutch is was I was asking about.I was running a 3 disc an have welded hub up an made a 5 disc now. Just don t think I got a good job setting it up at dealer. Had a 180 psi but slipped it on 2nd pass.
by
risky
-
Forum
I was needing some info on where to get a 5 disc clutch set up at. Took to dealer an didn t hold. They wasn t familiar with what I was doin with the hubs welded together. Would like to know of anywhere in southern ky or middle tenn that was experienced. Thanks for any help!
by
risky
-
Forum
Thanks Deere puller. Just got one that can t get took off in 8 th but easly in 7th. Just tryin to explore options without goin to 3 speed trans.
by
risky
-
Forum
Does a john deere 4010/4020 gas tractor have a faster rear end ratio than a diesel? If so how much.
by
risky
-
Forum
Page 2 of 2
Pages: 12