Page 3 of 3
Pages: 123
Results 61 - 83 of 83
Anyone??
by
970 case lss
-
Forum
Can I change my p3000 front bearing retainer myself or is it a pump shop job?
What other changes are ness? Thanks
by
970 case lss
-
Forum
1 204 745 7591
by
970 case lss
-
Forum
Anyone??
by
970 case lss
-
Forum
How much pressure will the common 4" silicone air to air hoses hold in?
Will they hold 70 lbs with tie bars from air pipe to cooler?
Thanks
by
970 case lss
-
Forum
Thanks for the input
by
970 case lss
-
Forum
I have already built a aluminum box that sits inside my front frame rails
by
970 case lss
-
Forum
What are guys doing to insulate ice boxes? Is it ness if you fill with ice promptly before pulling? Thanks in advance for any input
by
970 case lss
-
Forum
504 case, 700cc fuel, 3x3 gt42, ice cooler, intake pipe water. Looking for a good starting amount of water to run. Thanks for the input
by
970 case lss
-
Forum
Is dual fuel inlet a must on 700 cc p 3000?
by
970 case lss
-
Forum
How much oil are guys running in a 30 or 70 series case rear
by
970 case lss
-
Forum
Fill the cylinder prior to installing the lines, then the only air to purge is from the lines. That's how I do mine, takes ten min and way less turning back and forth
by
970 case lss
-
Forum
Thanks for the input, much appreciated
by
970 case lss
-
Forum
Wimers fuel injectors, good??
by
970 case lss
-
Forum
I bought it used for 600$ off the for sale page a few months ago
by
970 case lss
-
Forum
Just finished installing one last night, easy to bleed, steers nice on a 7500 lb tractor. By far the way to go on a lighter machine, no steering shaft to deal with
by
970 case lss
-
Forum
Building a 504 case open rpm p pump, 750cc fuel, ice cooler, water Inj, with a 3x3 gt 42. Just wondering if a 128 exhaust housing will be too big. Thoughts?
by
970 case lss
-
Forum
I built in .015 clearance to a 4.625 bore case motor, haven't run yet but that's what powerbore Brent recommended
Tyler
by
970 case lss
-
Forum
Are guys running port Inj with a cooler or just intake pipe nozzles.
What's an approx amount of water for an Intercooled 504, 750cc, 3x3 turbo open rpm
by
970 case lss
-
Forum
What style of enderle nozzle holders are guys using? Hat or blower port?
by
970 case lss
-
Forum
Case 1175, what power level are the factory rings and pistons able to handle?
by
970 case lss
-
Forum
I was hoping someone would answer this one because I was wondering as well
by
970 case lss
-
Forum
Here are some photos I found from 1989 when Arlin was pulling with the N-K Prostock association
Lil Nasty photo was from Beatrice NE, and the Aaron's Dream photo was from Wahoo, NE
The last I heard the Lil Nasty 1206 was in a building that burnt and that was many years ago.
I don't know what happen to it after that.
by
970 case lss
-
Forum
Page 3 of 3
Pages: 123