02:05:18am, Monday, May 20, 2024
torque eliminator question
|
Registered: 04/12/2008 Posts: 399 |
Does anyone know right off hand what support bearing guys are using in the front TA housing whrn you convert from the clutch packs to a strait shaft? Last time I did this on a 1566, I bought a complete kit. This time I found a good deal on a straight shaft, but dont have the front housing with the bearing. Perhaps someone out there has the part I'm looking for??? Neil 608-317-7321 thanks guys. |
Re: torque eliminator question
|
Registered: 09/03/2010 Posts: 393 |
Im not sure but can't you use the one that is with the TA setup? I had a eliminator kit once from HYCapacity that I couldn't get to go back together and I took the bearing support out of the front of the kit and just used the support out of the TA and it worked fine. ?? This was on a 806. Edited 1 time(s). Last edit at 04/30/2015 02:32PM by farmall puller. |
Re: torque eliminator question
|
Registered: 04/12/2008 Posts: 399 |
I have a torque sitting here that I just removed from a 1466. I slid the front carrier off of it, and thought I would put a bearing in it for strength. Maybe a guy doesnt need to. I believe they are all the same. I can block the three supply tube holes easy enough. I was just wondering if anyone knew what bearing most kits came with. I would like to come apart and go back together fast. Time is at a premium this time of year. Thanks. |
Website Statistics
Global: Topics: 38,785, Posts: 229,971, Members: 3,340.
This forum: Topics: 37,099, Posts: 226,049.
Global: Topics: 38,785, Posts: 229,971, Members: 3,340.
This forum: Topics: 37,099, Posts: 226,049.
Our newest member Jacklovik2009