llss chassis prep- bull pinion shaft question? January 01, 2016 06:08AM
Looks to me like a 560 chassis with its roughly 18.4:1 final drive ratio would work quite well for a diesel llss. After the usual suspects are addressed- Billit one piece input shaft and billit carrier, what else is recommended? Someone mentioned in a previous post that a guy would need a set of bull pinion shafts----- Why? Are there other carriers that can be machined into the 560? Perhaps the 706 carrier? Is there a need to swap out the side gears in the 560 case for a set with larger splines? Anyone out there with time to enlighten me as to what guys arr doing to toughen these up?
Reply Quote

Newer Topic Older Topic

Author:

Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 39,533, Posts: 235,320, Members: 3,523.
This forum: Topics: 37,969, Posts: 231,353.

Website Daily and Monthy Hits: http://pulloff.com/webalizer

Our newest member Neill Farms