06:35:26pm, Friday, May 03, 2024
Water Injection - Port vs Crossover Pipe
|
WaterInj
|
Looking for advice on water injection. Planning on running enderle nozzles. What's better - Port injection (6 nozzles tapped in the intake manifold) or run 2-3 in the x-pipe going into the intake manifold? |
Re: Water Injection - Port vs Crossover Pipe
|
Eddie
|
Both. Most in cross,use ports to equal cylinder temps |
Re: Water Injection - Port vs Crossover Pipe
|
WaterInj
|
So if I wanted to run ~40oz in a pass for example, you're saying to run bigger nozzles in the cross pipe and small nozzles in each port |
Re: Water Injection - Port vs Crossover Pipe
|
Moderator Registered: 03/19/2018 Posts: 664 |
Yes. In the crossover allows maximum mixing time (cooling) to occur. Ideally, no ports would need to be on, but if you have a hot hole, that's where you can control that.
CP |
Re: Water Injection - Port vs Crossover Pipe
|
Registered: 10/21/2008 Posts: 756 |
Where in the crossover pipe is the optimum placement for water injection? I know that there is radial air flow close to the turbocharger, does that radial flow continue continue into the intake manifold? |
Website Statistics
Global: Topics: 38,686, Posts: 229,788, Members: 3,328.
This forum: Topics: 37,080, Posts: 225,952.
Global: Topics: 38,686, Posts: 229,788, Members: 3,328.
This forum: Topics: 37,080, Posts: 225,952.
Our newest member Jason