11:26:32pm, Sunday, May 05, 2024
? for limproinmo
|
A4
|
I just had my 4010 go down the track and near the end there was a snap . When I tried to back up to the sled the engine labored and the tractor did not move.All the forward gears seem ok.Any suggestions before I tare into it? 3-400 hp |
Re: ? for limproinmo
|
Registered: 09/17/2008 Posts: 157 |
Stock tranny? It goes into and moves in all the forward gears, just not reverse? |
Re: ? for limproinmo
|
A4
|
Yes,It goes in the reverse slot but won't move just pulls down the motor,just curious where to start looking.Its the older 4010 with the stock light axles.
thanks |
Re: ? for limproinmo
|
Registered: 09/17/2008 Posts: 157 |
Hard to say, but my guess would be something on top shaft if all forward gears work. Pull the top cover off transmission and take a look at the top shaft is all I can tell ya. Good luck. |
Re: ? for limproinmo
|
Registered: 05/29/2008 Posts: 161 |
could also be A-range has seized to differential drive shaft. |
Website Statistics
Global: Topics: 38,704, Posts: 229,805, Members: 3,330.
This forum: Topics: 37,081, Posts: 225,952.
Global: Topics: 38,704, Posts: 229,805, Members: 3,330.
This forum: Topics: 37,081, Posts: 225,952.
Our newest member LT Limited Pro