Cummins cam March 11, 2023 10:57PM
On a 6.7.
Will a rear gear train cam,that has the bolt on gear,work in a front gear train motor ?
Thinking over drilling the holes a bit would provide some adjustment.
And could use those bolts to make a flange to drive a distributor.
Are the lobes ground right so it can be just turned around and still be usable?
Reply Quote

Re: Cummins cam March 12, 2023 11:14PM
There is no provision for a gear on the front of a rear gear cam
Reply Quote

Re: Cummins cam March 13, 2023 12:44AM
Can ya just turn it around ?
Bearings and lobes should be in same place front to back.
Reply Quote

Re: Cummins cam March 13, 2023 07:15AM
the rotation would be the same, but grind not made to go backwards.
Reply Quote

Re: Cummins cam March 13, 2023 01:43PM
The valve sequence will be off if you swap ends with it.
Reply Quote

Re: Cummins cam March 14, 2023 09:42AM
drill and tap the end of your camshaft to run your distributer
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,641, Posts: 229,707, Members: 3,325.
This forum: Topics: 37,067, Posts: 225,903.

Our newest member JD_8520