05:25:25pm, Sunday, April 28, 2024
Cummins cam
|
Ol1755
|
On a 6.7.
Will a rear gear train cam,that has the bolt on gear,work in a front gear train motor ? Thinking over drilling the holes a bit would provide some adjustment. And could use those bolts to make a flange to drive a distributor. Are the lobes ground right so it can be just turned around and still be usable? |
Re: Cummins cam
|
Registered: 12/31/2016 Posts: 50 |
There is no provision for a gear on the front of a rear gear cam |
Re: Cummins cam
|
Ol1755
|
Can ya just turn it around ?
Bearings and lobes should be in same place front to back. |
Re: Cummins cam
|
around
|
the rotation would be the same, but grind not made to go backwards. |
Re: Cummins cam
|
Registered: 07/06/2017 Posts: 369 |
The valve sequence will be off if you swap ends with it. |
Re: Cummins cam
|
Registered: 10/30/2018 Posts: 749 |
drill and tap the end of your camshaft to run your distributer |
Website Statistics
Global: Topics: 38,640, Posts: 229,706, Members: 3,325.
This forum: Topics: 37,067, Posts: 225,903.
Global: Topics: 38,640, Posts: 229,706, Members: 3,325.
This forum: Topics: 37,067, Posts: 225,903.
Our newest member JD_8520