02:04:08am, Monday, April 29, 2024
any information for or against using a2940,john deere.6000# pulling tractor.
|
looking for information on using a john deere 2940, for a 6000#.360 cube.3000,RPM class.good idea?or bad? |
Re: any information for or against using a2940,john deere.6000# pulling tractor.
|
Registered: 03/31/2008 Posts: 762 |
I think it would work if you are ready and able to do your own work and make parts. Probably not a lot of custom parts already designed. I talked to a guy in the Ky area that ran Superstock with a 2840 in the 90s, so I’d imagine it’s strong enough.
For a 3000 RPM class I think you are going to want to stroke a 329 with a 414 crank and a custom smaller piston rather than drop in a 359. The 414 crank is not going to just drop in though, or depending upon your rules decube a 414. |
Re: any information for or against using a2940,john deere.6000# pulling tractor.
|
Registered: 08/02/2019 Posts: 43 |
I built a 360 with 6068 crank and small bore.
I also think with the right parts the 2940 rear would be fine if done right. Stick a pro fab in front of rearend possibly. |
Re: any information for or against using a2940,john deere.6000# pulling tractor.
|
Sam
|
How’s it run? What pump and turbo?3000rpm? |
Website Statistics
Global: Topics: 38,643, Posts: 229,709, Members: 3,325.
This forum: Topics: 37,067, Posts: 225,903.
Global: Topics: 38,643, Posts: 229,709, Members: 3,325.
This forum: Topics: 37,067, Posts: 225,903.
Our newest member JD_8520