05:17:01am, Tuesday, May 07, 2024
P pump to a pump
|
Going from p pump block to a pump. I got aluminum adapator I’m guessing you take the studs out of the block. What kind of bolt are u using to hold aluminum adapator to engine block. The heads have to be so small to clear the studs going into a pump. I tried a 12 point bolt and it’s still to tight. Any other options. My adapator didn’t come countersunk the 3/8 hole is .600 by .210 deep for the head and it got to be flush on top cause the a pump flange goes over the head. Thank you. |
Re: P pump to a pump
|
Registered: 08/13/2016 Posts: 93 |
Could you use an Allen head bolt and machine it to fit? |
Re: P pump to a pump
|
Done it
|
Look into low profile socket head cap screws or button head cap screws.
I’ve done the same thing, but I always made them out of steel with counter sunk Allen head cap screws. |
Website Statistics
Global: Topics: 38,717, Posts: 229,825, Members: 3,330.
This forum: Topics: 37,083, Posts: 225,961.
Global: Topics: 38,717, Posts: 229,825, Members: 3,330.
This forum: Topics: 37,083, Posts: 225,961.
Our newest member LT Limited Pro