01:49:34am, Sunday, May 05, 2024
466 stroker
|
Looking to build a 700 ish cube 466. Will be naturally aspirated gasoline. Looking to either buy a old billet 6” crank and offset it or just weld up a stock one. Can you run 2.5” rod journals? 14:1 compression. Bore will be 4.875. Thoughts on the offset to 2.5 ? |
Re: 466 stroker
|
Puller 1155
|
I recommend doing a 5" bore and 6" stroke. That gives you 706+ cubic inches. That's easier done than trying to make longer stroke not to mention more parts are available for that setup. |
Re: 466 stroker
|
Can you still run full water with 5”? I didn’t know 5 was even possible. Appreciate the info |
Re: 466 stroker
|
Moderator Registered: 03/19/2018 Posts: 664 |
Have a conversation with Chuck Lewis and Ed & Scott Shoobridge. They've both done them out to 900ci and would be good resources.
CP |
Re: 466 stroker
|
Puller 1155
|
Brent Payne at Genes Machine in Hamilton Ohio I believe has done 5 inch bores of which I believe will need deck plated and curdled. I see no reason why you cannot run water. Brent can help you I'm sure. As for 900 inches in a 466 block, I'm sure as Cpr said, it can probably be done, however I am certain that it would be very exotic and I personally feel that reliability would suffer? |
Website Statistics
Global: Topics: 38,697, Posts: 229,795, Members: 3,329.
This forum: Topics: 37,081, Posts: 225,949.
Global: Topics: 38,697, Posts: 229,795, Members: 3,329.
This forum: Topics: 37,081, Posts: 225,949.
Our newest member CBeard