03:25:58am, Saturday, May 18, 2024
size of an 8.1 jd block
|
Anonymous User
|
what is the frame width of an 8.1 jd block compaired to an 7.6 |
Re: size of an 8.1 jd block
|
Registered: 12/19/2010 Posts: 163 |
don't know about a 7.6, but it is the same as an older 466 block. |
Re: size of an 8.1 jd block
|
Registered: 03/13/2009 Posts: 220 |
I have seen two different 8.1 blocks and one was narrow and one was wide. I think it depends on what they were out of. The narrow one also had two less bolt holes where it bolts to the bellhousing. Edited 1 time(s). Last edit at 03/03/2011 12:52PM by J&R Machine. |
Re: size of an 8.1 jd block
|
Anonymous User
|
ok thanks it needs to match the 466 block. |
Re: size of an 8.1 jd block
|
Registered: 12/19/2010 Posts: 163 |
I have used one out of a combine, and one out of an industrial eguipment. both fit fine in my frame rails, which had a 404, then 466. Only difference was old block(466) used 3/4 dia bolts and the 8.1 use's 5/8 dia bolts. The Front mounts of the 8.1 are in a slightly different location, but the back are the same. Not saying there isn't a narrow block, but i haven't run into it yet. I have the one out of the combine still that i would sell. |
Re: size of an 8.1 jd block
|
changer
|
So what has to be done to replace a 466 with a 8.1, will the8.1 bolt up to the original rails this is a 4240 |
Website Statistics
Global: Topics: 38,777, Posts: 229,949, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,034.
Global: Topics: 38,777, Posts: 229,949, Members: 3,338.
This forum: Topics: 37,098, Posts: 226,034.
Our newest member Jacklovik2009