Page 1 of 1 Pages: 1
Results 1 - 14 of 14
Riverside Built 55 Series Alcohol Cylinder Head. Ported, polished, heavy springs, inconel valves, steel bridges, big rocker shaft, spacers, billet hold downs, set of billet aluminum roller rockers, and new set of Crutchfield Machine billet steel roller rockers. Fresh, ready to bolt on. $5,000.00 OBO.
Call or Text 864-328-7640
by
Drifter
-
For Sale
I'm using the setup that Blackbourn sells, on my HvySS. It is slick. You can steer the tractor with your pinky finger. Wish I would've had it years ago.
by
Drifter
-
Forum
I sold all my .450 heads a few years back. I could probably come up with another one if needed, but those heads are getting hard to come by and they are very expensive. The one I ran on my old tractor, after the .450, was a .562. The real key to making them work though, is how it is setup, inj opening psi, and how it is fed. As far as rpm, yeah there is a certain point where the fuel drops off,
by
Drifter
-
Forum
Ron Perry 765-427-3961
by
Drifter
-
Forum
Brett, did you use the liquid, or putty type? I've got a small place on one of pulling tires also. I didn't see it on Grainger's website, but Staples offers it on their site for about $62. After reading a little about it, it appears that it may be best to use primer, also? Thanks
by
Drifter
-
Forum
Travis Trent, in east TN, does an excellent job making sheetmetal. 423-231-2525
by
Drifter
-
Forum
Sidewinder explosion at Keystone
by
Drifter
-
Forum
Not sure who took this video, but it came off of Facebook
by
Drifter
-
Forum
The fenders diid not tilt forward until it over revved, and blew the loots out. Watch the fenders when you watch the video and you will clearly see what happened. Broken drive line - reaction time + over revved engine = explosion! Bad deal indeed. One side of the tie bars was left holding it together, but barely. Parts and pieces went downward onto the ground as intended. If I was gonna change a
by
Drifter
-
Forum
Lots of vehicles, TONS of people going through the fair. Hard hooking track for big tires. Takes lots of front end weight and power. Just aggrevating to get out and in the place.
by
Drifter
-
Forum
What is the best oil - brand / weight, to use in a 3 speed small block Deere transmission? It's a Ron Perry setup in a 4010 housing with the gear pump on the back of the top shaft.
by
Drifter
-
Forum
Thanks Bryan........
by
Drifter
-
Forum
Thanks Crutch... This is the first video of it that I've seen,with me driving it..
How much would you charge to put it on a disc and mail it to me? I can't get high speed internet at home,and would like to be able to download it on my home computer......
by
Drifter
-
Forum
Did any of ya'll happen to get my run on camera,fri night??? Woodyard Express Hvy SS......
Thanks,
Andy Dutton
by
Drifter
-
Forum