Page 1 of 1 Pages: 1
Results 1 - 17 of 17
Nice set of 8 ply 18.4x38 Firestone 151s for sale. Tires are mounted on 16 inch pressed steel wheels. Centers are all the way to the outside in the wheels. $1000 located in southern Ky. 2706221655. Pictures available. Thanks.
by
Jake12
-
For Sale
IH-560 you’re welcome. We have ran the w6 setup before and had good luck with them. Don’t hold me to this but I think we lost somewhere around 115-120 lbs total by doing the swap. As mentioned CAP Brothers built our hubs so we could remove them if something happened. Good luck with finding a set they are getting harder to find. The best setup to look for would be a wheatland 400 or 450 if you cou
by
Jake12
-
Forum
IH 560 his cell is 270-622-1657
by
Jake12
-
Forum
If you’re wanting to lighten it up and speed it up at the same time, use a 400 to start with. As previously stated the simplest thing to do is decide what speed you’re wanting to run and get a constant mesh assembly from Karl at Atlas. Once you get the constant mesh set get a fourth gear set as well so you can have a three speed setup. We done this for many years. 3rd gear is the fastest pulling
by
Jake12
-
Forum
Better just go ahead and contact atlas and get a gear set combination on the way or a atlas max because 5th gear won’t last long at all.
by
Jake12
-
Forum
I certainly agree numbers don’t lie but, with that being said, is it a weight issue that’s pushed pullers away from the LLSS class or the fact that if you do good and beat a certain few your always considered to have been cheating? Looks as if TNT may have turned to more of a truck pulling organization.
by
Jake12
-
Forum
Lewis if you are so negative on the small cube motors and think they won’t run with the larger cube motors then why in the heck are you even talking about the 3500 or 3800 rpm limit? One minute you say 3800 rpm is ok then under different usernames you say lock it in at 3500rpm? We all know you ain’t going to build @#$%&, but if I was as smart as you were I would definitely be working for NASA.You
by
Jake12
-
Forum
“Like to know” the rules are listed below. We would be happy to answer any stupid questions you might have about this stupid class. Your exactly right, rules has changed and the reason being is because the original turbos would not hold up. The 3800 rpm is to accommodate for the small cube engines, this rule can be changed with 100% vote. Maybe they need more rpm, maybe they need less, we don’t k
by
Jake12
-
Forum
Went to cleeng.com and clicked the link and works great.
by
Jake12
-
Forum
Adam Draught does great work and very good to work with! Done this setup earlier this year. Two four gallon tanks mounted together.
by
Jake12
-
Forum
What will a 4010 john Deere rear end speed be with a ratio of 19:1,20 1/2:1, and 21-1 be? This will be running 3000rpms with a 3lm stock charger. Thanks
by
Jake12
-
Forum
April 18th first pull for skap at fosters
by
Jake12
-
Forum
Does anyone make a setup like this for a 560?
by
Jake12
-
Forum
Does anyone make or have a complete one piece hood assembly with all the sheetmetal for a 560? thanks
by
Jake12
-
Forum
Where could you find a 19/47 ring and pinion?
by
Jake12
-
Forum
Be lots easier to put in a 560 than a 460!
by
Jake12
-
Forum