Page 2 of 2
Pages: 12
Results 31 - 44 of 44
What size are the bolts?
ARP has a generic torque table on their website.
Use their lube. I did some tests with clamping force at rated torque and their lube was the best of what was tested. I plan to put the tests on Youtube when I get done with the editing.
Ed.
by
atex57
-
Forum
Steve Neuman may have something. 608/343-5410
by
atex57
-
Forum
Check with Randy at Quality Performance 715/659-5152. He regrinds and probably has new.
Ed.
by
atex57
-
Forum
Any hydraulics shop should have it available in bulk or can order it. What size do you need? I do not usually keep much here but can order it in.
Ed.
by
atex57
-
Forum
You can give a call 608 675 3325
Ed.
by
atex57
-
Forum
We make and sell custom studs for engine builders. At 3000RPM and 850 HP, stock bolts are plenty good. Just do a retorque after warming it up.
Ed.
by
atex57
-
Forum
Get the dimensions and call a JD dealer. They have a good selection available. That's where I go for smaller quantities.
Ed.
by
atex57
-
Forum
Hey Bill! Did you tell them its in Wisconsin? Is the Lions club gonna have steaks again this year?
Ed.
by
atex57
-
Forum
Actually if you think of an Oliver as having 2 three speed transmissions instead of a JD with 4 two speeds it comes out better. Oh, and then Oliver had a three on the go shift, when did JD find out about a TA system? ;-)
Ed.
by
atex57
-
Forum
What do you mean by high? 9/16 studs at 190Kpsi are rated 180 pounds of torque, they will yield at about 240. They only need 3/4 minimum of thread in the block to break the stud before stripping.
Ed.
by
atex57
-
Forum
A 1.25" hole will save you 4.17 pounds per foot.
Ed.
by
atex57
-
Forum
Oliver had a PTO delete on some of their Wheatland models. It was a shorter shaft that stopped at the pump. No idea what held it in.
Ed.
by
atex57
-
Forum
For me, making puller parts is an increasing sideline to my usual machine shop work. I have thread rollers and a heat treat furnace so rolled thread studs are a good sideline, gear cutters let me made timing gears and such. Don't put all my eggs in one basket.
Ed.
by
atex57
-
Forum
Drop the whole 310 in and watch her go!
Ed.
by
atex57
-
Forum
Page 2 of 2
Pages: 12