585 jd engine February 25, 2019 02:07AM
How to make a 585 cubic inch small block Deere engine??
Reply Quote

Re: 585 jd engine February 25, 2019 02:51AM
The best running John Deere engine i had was a 585 cu. in. The bore was 4.750" and the stroke was 5.500". I'm sure there is other ways to get there, but this is what i did.
Reply Quote

Re: 585 jd engine February 25, 2019 03:04AM
Do you change pin height in piston or change rods also??
Reply Quote

Re: 585 jd engine February 25, 2019 06:05AM
I believe most guys run an ih rod from the 466?
Reply Quote

Re: 585 jd engine February 26, 2019 02:20AM
We used Factory IH rods with 1.625 piston pins. We also had them heat treated and resized. The IH rod is not as wide as the Deere rod on the Crankshaft journal, so we just let them float and never had any problems.
Reply Quote

Newer Topic Older Topic

Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message:
Website Statistics
Global: Topics: 38,766, Posts: 229,932, Members: 3,337.
This forum: Topics: 37,095, Posts: 226,025.

Our newest member DANNY.WAINSCOTT@YAHOO.COM