02:14:29am, Thursday, May 16, 2024
585 jd engine
|
How to make a 585 cubic inch small block Deere engine?? |
Re: 585 jd engine
|
Registered: 10/18/2011 Posts: 262 |
The best running John Deere engine i had was a 585 cu. in. The bore was 4.750" and the stroke was 5.500". I'm sure there is other ways to get there, but this is what i did. |
Re: 585 jd engine
|
Do you change pin height in piston or change rods also?? |
Re: 585 jd engine
|
Registered: 08/03/2008 Posts: 438 |
I believe most guys run an ih rod from the 466? |
Re: 585 jd engine
|
Registered: 10/18/2011 Posts: 262 |
We used Factory IH rods with 1.625 piston pins. We also had them heat treated and resized. The IH rod is not as wide as the Deere rod on the Crankshaft journal, so we just let them float and never had any problems. |
Website Statistics
Global: Topics: 38,766, Posts: 229,932, Members: 3,337.
This forum: Topics: 37,095, Posts: 226,025.
Global: Topics: 38,766, Posts: 229,932, Members: 3,337.
This forum: Topics: 37,095, Posts: 226,025.
Our newest member DANNY.WAINSCOTT@YAHOO.COM