Page 1 of 1 Pages: 1
Results 1 - 20 of 20
Would a 8.3 cummins be legal to run in front of a 1100 rearend?
by
mark67
-
Forum
Uber is what picks you up from the bar when you drink to much lol
by
mark67
-
Forum
Ace Chassis has nice cage kits
by
mark67
-
Forum
That was one of my favorite tractors when I was a kid
by
mark67
-
Forum
I know this is an old topic but does a 466e flywheel have the same ring gear as the tractors are using? I have a junk 466e and was going to use the flywheel to check my starter location on the rear plate Im fabricating
by
mark67
-
Forum
DT well its 640 3" map groove now so going to 3" smooth bore would lose power that's why i suggested 3.6 smooth bore it would be a power increase but still no where close to 4.1 hp and I never suggested changing the name of the class that's your idea it's not called 3" superfarm now so why would the turbo size require a name change and again not saying these changes should happen
by
mark67
-
Forum
I don't think 540 is to big for light pro and that cubic inch limit allowed several older DSS to convert over to a single charger class. The 3.6 turbo would be a good choice for super farm if you were to change the turbo rule because several builders already make a turbo that size for the prostock diesel pickups and it might be enough added HP to smooth out there ride. Also the 3.6 turbo o
by
mark67
-
Forum
yep Adam does real nice work
by
mark67
-
Forum
Is there anyone headed to Ohio going through Missouri I have a part that needs to get there asap I'm about 30 miles west of St Louis Thanks
314-372-1999
by
mark67
-
Forum
I thought there was supposed to be a 3.0 diesel truck class also
by
mark67
-
Forum
What is 8000lb open is that 3.0 diesel pickups?
by
mark67
-
Forum
Sorry to hear that Karl I really enjoyed having a booth next to you guys at Gordyville last year hang in there
by
mark67
-
Forum
Does anyone know the calculation for holset cm housing to a/r Im needing a turbo with the equivalent exhaust housing of an hx82 36cm housing. I found a turbonetics and it has a 1.70 a/r just wondering if its close enough
by
mark67
-
Forum
Any chance of a light pro class ever starting in Missouri?
by
mark67
-
Forum
Ace does very nice work you are going to have to wait a while with anyone but ace is where I would go for a complete roller or turn key tractor
by
mark67
-
Forum
Thanks for the info
by
mark67
-
Forum
I need to know what size third member studs are on a sqhd housing, I building a housing and only have the third member are they 9/16 or 5/8? thanks
by
mark67
-
Forum
I would think you would catch a lot of dirt coming down
by
mark67
-
Forum
Check these guys out they have schedule 10 and schedule 40 stainless at good prices schedule 40 may be a little better its thicker wall
www.acestainless.com
by
mark67
-
Forum